• View Option
• Grid view
• List view

 Interior of the Sabre 30 has a remarkably spacious and functional cruising layout, with standing room throughout. Forward cabin includes double v-berth, two full length bins, two drawers and four lockers. Head to port includes vanity with single sink with hot & cold pressurized water and manual foot pump, shower, teak towel rack,  toilet paper holder and teak faced mirror. Opposite the head is a hanging locker and additional storage. Salon has settee seating for six surrounding large table. The double leaf teak table folds up against a magazine rack on the main bulkhead. Port convertible settee extends to make a double berth. Starboard settee converts to single 6' 4" berth. Foldaway chart table is mounted at forward end of quarterberth to serve as navigation station and galley countertop extension. Aft to port is also a quarter berth.There is ample storage throughout the  cabin.

♦  Two large opening hatches

♦  Four opening ports w/screens

♦  Quarter berth 6'4"

♦  Fold away chart table mounted at the end of the quarter berth

♦  Dorade vent is molded in above the washroom

♦  Navigation station

♦  Filler cushions for v-berth and port side double berth

♦  Four DC lights in salon and two in v-berth ,two in head area

♦  Shower sump pump

The galley located aft to starboard is equipped to prepare nutritious meals and great snacks. 

♦  Two burner alcohol stove w/cutting board

♦  Stainless steel sink

♦  Pressurized hot and cold water

♦  Manual water foot pump

♦  Large ice box w/hinged top

♦  fold-down countertop extension

♦  Storage includes four drawers & five lockers 

♦  Built in waste basket

Fully rigged to enjoy offshore or inland sailing with sails in good condition.

♦  Aluminum mast and boom

♦  Internal jib halyard is led to a Lewmar #16 two-speed winch

♦  Internal main halyard is led to a Lewmar #8 winch

♦  Genoa sheets are led to blocks on coaming pads and then to Lewmar #40 two speed winches

♦  150% genoa

♦  Fully batten main sail

 Hull construction on the Sabre 30 is a single unit hand laminated fiberglass molding using alternating layers of mat and roving with additional reinforcing in high stress areas. Interior construction is of handcrafted teak and varnished mahogany. All trim, drawer fronts and locker doors are solid teak. Deck is hand laminated fiberglass with balsa stiffening and molded in non-skid deck surface. Toerails, handrails, coaming caps and trim are all teak. Comfortable shaded cockpit seating for six under bimini.

♦ Full bimini

♦ Starboard folding cockpit table

♦ Binnacle mounted cup holders

♦ Edson wheel steering

♦ Cockpit cushions

♦ Two cockpit lockers - one deep, one shallow

♦ Large foredeck anchor locker

♦ Stainless steel swim ladder

♦ Stainless steel bow and stern rails

♦ Bruce anchor w/chain & rode

♦ Life ring

♦ Shore power

♦ 30 amp shore power cord

♦ Two Group 31 batteries

♦ Dual battery switch

♦ Battery tester

♦ Hot water heater

♦ Electronics: Depth & speed gauges

♦ Gauges: oil pressure, temp, voltage, fuel, tach & hour meter